Gewindeschneidtechnik · Thread Cutting Technology
Gewindebohrer · Taps 248 M MF UNC UN-8 UNF UNEF G, Rp NPSM,NPSF NPT, NPTF Rc, W BSW, BSF MJ UNJC,UNJF Pg EG (STI) SELF-LOCK Tr, Tr-F Rd Zubehör Accessories Product Finder v c Tech. Info 1.3 EMUGE Gewindebohrer-Grundformen 1.3 Basic types of our EMUGE taps Rekord A STEEL GG GJV GAL MG FK MS H HCUT Z SPEED • Gerade Nutenform • Anschnittform C (2-3 Gänge) • Anschnittform E (1,5-2 Gänge) • Für Grundloch- und Durchgangslochgewinde Bemerkung: Vorwiegend für kurzspanendes Material. Die Nuten können nur einen Teil der Späne aufnehmen. Ein Spantransport in Axialrichtung erfolgt praktisch nicht. Tiefe Grundloch- oder Durchgangslochgewinde sollten daher nicht in langspanendes Material gebohrt werden. • Straight flutes • Chamfer form C (2-3 threads) • Chamfer form E (1.5-2 threads) • For blind hole and through hole threads Note: Especially for short-chipping material. The flutes can hold only a part of the chips. There is practically no chip transport in an axial direction. We do not recommend using this tap type in deep blind hole or through hole threads in long-chipping material. Rekord B STEEL-L STEEL-M STEEL-H VA AL Z Z-SPEED • Gerade Nutenform mit Schälanschnitt • Anschnittform B (4-5 Gänge) • Für Durchgangslochgewinde Bemerkung: Typisches Werkzeug für Durchgangslochgewinde in langspanenden Materialien. Der Schälanschnitt schiebt die Späne eng gerollt nach vorne und verhindert ein Verstopfen der Spannuten. Der Kühlschmierstoff kann ungehindert nachfließen. Nicht im Umkehrschnitt einsetzen! • Straight flutes with spiral point • Chamfer form B (4-5 threads) • For through hole threads Note: Typical tool for through hole threads in long-chipping material. The spiral point pushes the tightly rolled chips ahead and prevents clogging of the flutes. Coolant-lubricant can flow freely. Do not use this tap type for a reverse cut! Rekord C TI NI • 8-15° linksgedrallte Spannuten • Anschnittform D (4-5 Gänge) • Für Durchgangslochgewinde Bemerkung: Die linksgedrallten Nuten schieben die Späne nach vorne. Im Gegensatz zur Schälanschnittausführung (Rekord B) verläuft der Spanwinkel über die gesamte Anschnittlänge nahezu konstant. Dies ergibt sehr stabile Anschnittzähne für hochfeste Materialien. • 8-15° left-hand spiral flutes • Chamfer form D (4-5 threads) • For through hole threads Note: The left-hand spiral flutes push the chips ahead. As opposed to the spiral-point design (Rekord B), the rake angle remains constant over the complete length of the chamfer. This means extremely stable chamfer teeth for high-strength materials.
RkJQdWJsaXNoZXIy NjMxNTU=